That is beautiful, wish I had time to carve it. Would be an awesome gift to a new mother.

Sorry, missed your reply. Did you move the 1 1/2 thick wood to the other machine along with the card? Have had the same response as you regarding bein...

Not sure what the prob is, possible to try another carve just to see if it gets past this point or stops the same way. Should prove if it is the proje...

Haven't done a load for a while but seem to remember it comes up in the Demo mode. To be able to upload and run a project you have to register with Ca...

Managed to get one done, wife likes so is a good one. Just curious if you used AI on it. 20260317_115208.jpg

Looks like you found the solution, works great. Pattern came out clean. Thx, Rick

Tried to make a pattern but everything turns out with a 'fuzzy' looking surface. Picture seems to have minute black pinholes when I enlarge it

Finished product is beautiful

Not to my knowledge, the old 'free' program was based on one of the servers that were eliminated. No place to download from nor to activate any older ...

A man of many talents. Had never heard of that flute but it looks intriguing to play. I can't carry a tune in a bucket with a lid on it without bring...

Not familiar with that model, have an early A machine from 2008 but am assuming the only source would be to contact Carvewright. They would be able to...

1. My understanding is that once the old designer is lost you can't reload it as a working program since there no longer is a server at carvewright to...

Sorry Oscar, didn't do anything for Valentines Day. Had some other issues that pulled me out of the shop. As they say, hopefully there will be next ye...