It should open in Designer when you click on it.
I have a question about the finished product... I do not see a cut path on the project, is it scroll sawed out after the carve?
It should open in Designer when you click on it.
I have a question about the finished product... I do not see a cut path on the project, is it scroll sawed out after the carve?
Last edited by PCOutlaw; 03-11-2013 at 08:16 AM.
pcoutlaw, when I put these 2 patterns together I did not do a cutout for it, I just use my bandsaw which gives a little better cutout in the sharp corners. Only takes about 15 mins to cut it out being careful and using pine. Maybe someone can do the outline and make it cutout.
CarverJerry
ver. 1.188 Win 7- 64b with 6 GB ram @ 2.8Ghz and dual 1Tb hard drives. Rock Chuck & Ringneck vacuum system hooked up to a Harbor Freight large vacuum. Center line text, conforming vectors.
This one has been a real hit - not the traditional Last Supper, but folks really like it.
Pattern's here on the Sharing Depot.
Livin' Life
Lovin' My Carvewright
hola haber si yo puedo agregar algo positivo
aqui van estas imagenes
Attachment 0
esto es lo que tengo
un saludo de españa
"Carved with Love"
Happiness comes from within.
But joy comes from helping others.
Measure twice... and then sneak up on it!
hola hay van las tallas
ultima cena.mpc
Attachment 0ultima cena 2.mpc
que las disfrute
Gracias, señor!!
"Carved with Love"
Happiness comes from within.
But joy comes from helping others.
Measure twice... and then sneak up on it!