I just sat here for the last 2 hrs. trying to make a simple pattern, I had used the tracing image file and had watched the tutorial another 2 times I had finished the pattern on tracing it and wanted to group the rainbow and the coins in a different groups and try to puff the rainbow when I was trying to group the rainbow the computer crashed, should I have group them as I went ? and there where points in the pattern that I needed to trim do what do I do to trim those unwanted spots. thanks for your help .
I give up on the pot of gold for now, I'm trying something a little easier, Connie posted this I think, well I got what I wanted except when I did the puff tool I lost one of the rays, I did a select all and then did the puff tool, the ray was on my carve list but got lost. can someone help me find it!... lol...it's getting late and I'm getting a little giddee..I do thank you ...
my first pattern, took me 14hrs. to get it, how would I get the out side edge to make a rounded sweep? I had to shrink the pattern to get it on the forum I don't know how else to do it.
It seems that everyone might be on vacation I asked for help on two different patterns, I'm starting to get.... way... back in the archives I am hoping some one Knows how to do this ....thank you
aokweld, take a look at this post http://forum.carvewright.com/showthr...Height-pattern it gives you the heights for each gray. Then change the colors to the gray you want for the height, then add some blur to round the edges. (pot of gold)
Using Designer 1.187, STL importer, Center line, conforming vectors, scanning probe/PE, and the ROCK chuck.