-
sweep tool
I'm trying to get the sweeps on just the ends of a box like the oramental box instead of all four sides.. could someone give me the easy way out instead of pushing buttons a thousand times...LoL
-
Try this thread http://forum.carvewright.com/showthr...suite-software look at post #7, and watch the video, it uses the rail sweep. This concept may be what you are looking for.
Using Designer 1.187, STL importer, Center line, conforming vectors, scanning probe/PE, and the ROCK chuck.
Eddie
-
I have went to the web site and it did not explane how do the left and right side of the carve leaving the top and bottom alone I did'nt get to take the easy way out I have already pressed the buttons a thousand times and still hav'nt figured it out...
-
I would need to see what you are working on at this point. Not sure what you are looking to do.
Using Designer 1.187, STL importer, Center line, conforming vectors, scanning probe/PE, and the ROCK chuck.
Eddie
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules