Help!!! I hope there is a fellow carver that can tell me what happened. Long story short. I ran about 15 Corian projects a few weeks ago and a few was of the eagle on the left, all came out great. Then I had to do about 6 wood
projects. So yesterday I needed to run this eagle again, so I up loaded it again from my desk where I had it saved from previous. Look at the right picture, what the heck happened. Them lines on there make it look like crap.
So I thought I did something wrong so I did another picture from previous, same result. So I've wasted about 5 pieces of Corian. I'm hoping someone has seen this before and can tell me exactly what happened. The machine
sounded and ran the same, I did't notice any difference.
Thanks, Bill