How can I delete the carve region from a lito? I just want the picture craved in.
Thanks,
Leo
How can I delete the carve region from a lito? I just want the picture craved in.
Thanks,
Leo
If the carve region has been applied there should be a blue square around the carve region icon. Just click on the icon again and it should take the carve region off the carve.
Just in case your pattern was yours from the beginning, this may help.
My "Download" link, below, has 2 specific lessons with the titles beginning with the words "Pattern Editor". They may give you what you wish.
If your obtained the pattern, from someone else, with the rectangle included you may need to go back to your source.
AskBud
AskBud Downloads =>> CLICK HERE
Lesson added 7/15/2012 Titles begin with "2D-3D Build a Pattern-Part-3"
CW Vacuum Head Project =>> CLICK HERE
AskBud Home Page =>> CLICK HERE <<=PC lessons or CW lessons
More than 1250 AskBud patterns vvv-CLICK BELOW-vvv
http://store.carvewright.com/manufac...ufacturerid=29
Bud
It's my pattern. I don't see your link
It's the first link in my signature below. It contains lots of sub links to various lessons and tips.
I'll put it here for you, so you may see it is the same as clicking in the signature area.
http://www2.wcoil.com/~nharbison/cw-...0downloads.htm
AskBud
AskBud Downloads =>> CLICK HERE
Lesson added 7/15/2012 Titles begin with "2D-3D Build a Pattern-Part-3"
CW Vacuum Head Project =>> CLICK HERE
AskBud Home Page =>> CLICK HERE <<=PC lessons or CW lessons
More than 1250 AskBud patterns vvv-CLICK BELOW-vvv
http://store.carvewright.com/manufac...ufacturerid=29