My nephew spotted this laser-etched clock:
I said we can do better than that. I found a 3D model online, imported it to pattern sculptor, altered the dish antenna a bit, and made a few other tweaks:
(I actually messed up the dish a bit, so I carved a separate one to salvage the project. The uploaded version should be good to go.)
This is a pierced carve using the 1/16" carving bit. I also used the 1/8" cutting bit to drill the hole for the shaft. There is a recess on the back for the clock mechanism - you'll need a long shaft mechanism. The clock is about 12" x 15". The project is Designer 1 and no additional software tools are needed. But it might be cool to carve a thicker one with the Designer 3 long bit.
I would have used longer hands if I had them.
Post a picture if you make one.