Hey all,
There is simply too much good information here! So much so, as I cannot find out what I did wrong. I'm attaching my template, which is essentially a shape that I intend to carve through the entire depth of the stock. As you will see, there's no 'cut path' for the shape, as I've done those easy enough... I thought I had it down, as I set my stock depth to be 3/4", and the stock itself IS 3/4".
Unfortunately, there's still a lot of stock down there in between the bottom of the carve and the back side. I was under the impression there was a way to make tabs - possibly manually? - but I cannot find the answer for the life of me.
Thanks, in advance!
Rick