What is your head pressure?
What version of the firmware are you using? It should be 3.102.
What is your head pressure?
What version of the firmware are you using? It should be 3.102.
Last edited by lynnfrwd; 01-26-2016 at 09:49 AM.
CarveWright CX Packaged System - starting at $2000
CarversClub 1 Year Subscription - $150.00/year
Adv. Support w/out CC membership - $25.00/issue
CarveWright Community Forum - PRICELESS!
My guess is...99% of us aren't mechanical/electrical engineers.
CarveWright CX Packaged System - starting at $2000
CarversClub 1 Year Subscription - $150.00/year
Adv. Support w/out CC membership - $25.00/issue
CarveWright Community Forum - PRICELESS!
Head pressure was right close to 80lbs if I remember correctly (I will check it again when I have a few minutes). The firmware version is 3.102 - I haven't had the machine a year, and it has under 100hrs on it. It was purchased new from LHR/Carvewright.
Your comfort level disassembling the machine and mine are two different metrics. Perhaps I can do it just fine with the skill set I have, and perhaps I may make a mistake that voids my warranty. I prefer not to take chances at this point.
The sawdust can cake up at the ends of the two compression rollers. It requires you remove the rollers and clean out the sawdust.
Look at these documents and see if that makes you feel more comfortable.
Troubleshooting doc: http://support.carvewright.com/stuck...oller-message/
Video: http://support.carvewright.com/clean...ssion-rollors/
Last edited by lynnfrwd; 01-26-2016 at 11:12 AM.
CarveWright CX Packaged System - starting at $2000
CarversClub 1 Year Subscription - $150.00/year
Adv. Support w/out CC membership - $25.00/issue
CarveWright Community Forum - PRICELESS!
RingNeckBlues
My patterns on the Depot
DC-INSERT It Just Sucks!
Proven to out perform all others!
Buy CarveWright
Colorado FaceBook Users Group
All patterns and projects that I share on the CarveWright forum are for your personal carving purpose. They are not to be shared, sold or posted on any other web site without permission from RingNeckBlues Designs.