JerryB:.
CarveWright START U Team Member
Using 1.187, Conform, PE/Probe, Centerline.
"Let's start sharing PTNs instead of MPCs so ALL SW versions can view & share"
Can you not carve the ball nose? Invert the nose pattern and get the machine to hollow it out so it just fits. Interesting double sided carve project in itself. (Maybe just dumb since I guess you could just cut off the nose.)
I seen wooded round 3/4 ball drawer pulls at Lowe's I didn't look to see If they had anything bigger that would look great if they come in 1" balls and they are flat on one side to be seated against the drawer and have a hole started for the screw. I think they was only $2.00 for two of em.
Jerry... I sure like your altered Schnoz Box. It is so much "you."
Thanks for the kind words everyone. Yup Sharon... all this must be my "funny" side. LOL I hope that I can figure out how to make a picture frame with clowns all around it. I think that will be my next "to learn and do".
JerryB:.
CarveWright START U Team Member
Using 1.187, Conform, PE/Probe, Centerline.
"Let's start sharing PTNs instead of MPCs so ALL SW versions can view & share"