Just got a CW, my second one. Plugged it in, inserted the card, flipped the On switch and nothing.
Are we still having power board problems.
Just got a CW, my second one. Plugged it in, inserted the card, flipped the On switch and nothing.
Are we still having power board problems.
Are you sure that the machine did not power up? I was thinking that I had a similar after a recent move. turned on the machine and nothing on the display. turns out the contrast button had been turned all the way down in the move. I simply adjusted this and the display came in fine. good luck.
The contrast dial is not working because no juice is getting to it. Looks like this CW is going back to Texas.
Does the y truck put up some resistance to movement by hand when the switch is on? (24V check)
Try swapping the card from your other machine.
It worked out of the factory so this could be something like the card... Likely at the factory they use the same card to test every machine in that line... So my thoughts are the card...
Favorite Saying.... "It's ALL About the Brass Roller"..... And "Use MASKING TAPE" for board skipping in the X or breaking bits.
Follow ME on Facebook http://www.facebook.com/pages/Accoun...50019051727074
www.PoconoDigitalWoodshop.com
www.AccountabilityTag.com
Ok, took the upper hand and flipped the CW on its side, removed the bottom to discover that the logic controller was not plugged in. Time to take a closer look at this CW.
RingNeckBlues
My patterns on the Depot
DC-INSERT It Just Sucks!
Proven to out perform all others!
Buy CarveWright
Colorado FaceBook Users Group
All patterns and projects that I share on the CarveWright forum are for your personal carving purpose. They are not to be shared, sold or posted on any other web site without permission from RingNeckBlues Designs.
New Machine, part 2. Hello, over the years(09) I have purchased many patterns, projects, and center line software. The Pc that used to run no longer runs. The old machine(b) made its way to the land fill. How can I re-license the patterns, projects, and center line to my new pc/machine.
CarveWright CX Packaged System - starting at $2000
CarversClub 1 Year Subscription - $150.00/year
Adv. Support w/out CC membership - $25.00/issue
CarveWright Community Forum - PRICELESS!