Jeff,
See Al's post #5.
http://forum.carvewright.com/showthr...t=C1+capacitor
Jeff,
See Al's post #5.
http://forum.carvewright.com/showthr...t=C1+capacitor
Thanks Dan,
I will pull the bottom off and check that. I was hoping for a return call from LHR but I am sure they are busy.
Thanks
Jeff
___________
Jeff Corder
Thanks for posting the link to a past post on the C1. Was painting signs last night until 3:30 AM. Deliver Day today and Visit the VA Doc for my 6 month tune up so I am just catching up.
I don't have any good brushes to measure but I did search Carbon Brush companies last year but couldn't find a match..... I have ordered the brushes from LHR in the past. Don't remember the price.....
AL
Here are some posts that are a year old or older on the cut motor. http://forum.carvewright.com/showthr...+motor+brushes
Last edited by Digitalwoodshop; 07-28-2009 at 08:49 PM.
Favorite Saying.... "It's ALL About the Brass Roller"..... And "Use MASKING TAPE" for board skipping in the X or breaking bits.
Follow ME on Facebook http://www.facebook.com/pages/Accoun...50019051727074
www.PoconoDigitalWoodshop.com
www.AccountabilityTag.com
Al thanks for the response. I know the late night thing and it sure catches up more than it did a few years ago. Hope the checkup went well. When LHR calls, I will try and get an idea of the length the brushes should be, these seemed pretty long, but then again, not sure how long they are new. If I find an answer to that, I will be sure and post it.
Thanks again
Jeff
___________
Jeff Corder
Al you were right on with the cover switch. The lid is not keeping it compressed. So until I get a chance to get a new switch or try and reposition this one, I just put a piece of tape on the tip of the cover portion that holds it in to make it a bit longer and it seems to have taken care of the problem.
I also spoke with LHR and that was the first thing they came up with as well...You and Robert at support were on the same page!
Thanks again
Jeff
___________
Jeff Corder