Has any made a cribbage board using a CW machine?
If so, can you describe the process and what bit to use??
Rick
Has any made a cribbage board using a CW machine?
If so, can you describe the process and what bit to use??
Rick
This is one cribbage board I put together, though I've made a few minor changes since then and haven't posted the updated MPC. http://forum.carvewright.com/showthread.php?t=7354
Attached is a picture of a carved board. Two bits were used for most of the work - 1/8" cutting bit for the holes and a 60 V-Groove for the outlines. I then used a manual router to edge rout with a roundover bit.
I like the spiral board. Very nice.
Would you mind uploading your latest project file?
Here's the final version of the board: http://forum.carvewright.com/showpos...41&postcount=8.