I was running my 1st long, long board thru, and the tracking got off, and wrinkled up the left sand paper belt. Anyone know of that'll be covered under warranty, and also how much are they?
I was running my 1st long, long board thru, and the tracking got off, and wrinkled up the left sand paper belt. Anyone know of that'll be covered under warranty, and also how much are they?
They are not covered under warranty. The belts are considered consumables, I believe. When I replaced mine after 450 hours they were $15.
belts are not covered under the warranted parts of the machine. They are about $26 per set and that includes shipping. I think when I bought mine they were $14 and $12 for shipping. They also have new kevlar belts but they run about $99 a set I think.
Good luck
Jeff
___________
Jeff Corder
TurtleCove,
You can reuse the belt after cutting of the damaged part!
Ken,
V-1, 2, & 3
When the People fear their Government, there is Tyranny.
When the Government fears the People, there is Liberty.
- Thomas Jefferson
You must be the change you wish to see in the world.
- Mohandas Gandhi
I'll give it a shot, Doc.
I'll read the .pdf on how to get it off, then trim off the bad part, and give it a 'go' again.
Sound good?
Cutting off the damaged part will keep you going for a while but you gotta admit, those new kevlar belts are pretty cool.
http://forum.carvewright.com/showthr...=traction+belt
for the belts like came on them at a great price try the site listed in this thread
I got 4 belts and shipping for less than the cost of two belts
"Our principles are the springs of our actions. Our actions, the springs of our happiness or misery. Too much care, therefore, cannot be taken in forming our principles." Red Skelton
I have 1.132 and previous versions back to 1.19 on standby
Please support Cystic Fibrosis