Got just one word for ya after a project like that Al....SLEEP!!
Great work Sir, thanks for look'n out for our finest home grown.
Got just one word for ya after a project like that Al....SLEEP!!
Great work Sir, thanks for look'n out for our finest home grown.
Bernie :^)
Wisdom has no value unless it's shared.
Ver. 177 in Test mode Ver.134 in reserve
[QUOTE=LollyWood;71036]Got just one word for ya after a project like that Al....SLEEP!!
Man, do I agree! I'm tired just thinking about all that work.
Jerry
Joanne and me enjoying a beautiful fall in Spearfish Canyon in the Black Hills.
Are there any PDF files on a z stall - I ve searched the forum and could on find 246 error with a scanning probe. Mine is just carving. The motor travels smoothly.???? Any suggestions out there???
Al
You started to tell me what you were using to do your accountability tags'
I am using 1/8 3 ply made by rowmark are u using anytrhing different and how well does it work.
William
Finally got around to making something showing how the probe is cabled to the controller. Sorry for the drawings, not any good with paint or other programs so just drew them on a word doc. Normally you can use the menu and watch the sensor but if it never changes this might help prove where the problem lies.
Good luck Rick H.
Rick
That will come in handy one of the days. Thank You
Here is what I got from LHR. Hope you have better luck than I did with the calibration.
Mark
Does any one know the size of the nut on the back side of the Z truck?
The two on the right are ex centric as i have been told, I would need to tighten them to remove the play in the truck. But haven't seen any ware that tells
the size of the wrench.
Thanks to all that can help!
Lee
Now using 1.150
Pop's Fix It Shop, We won't make it any worse.. Using "A" machines 1.187 1.188 ,2.007, 3.103
2 Machines no waiting.
To remove and replace the Z-truck you will need the following tools:
• 4mm Allen wrench
• 12mm stamped flat wrench
• #2 Phillips screwdriver (magnetic tip preferred)
• Loctite
Thank You for the info! Have the ROCK chuck and after first carve found the truck a little loose, fix it now worry later!
Thanks again and Cheers
Lee
Pop's Fix It Shop, We won't make it any worse.. Using "A" machines 1.187 1.188 ,2.007, 3.103
2 Machines no waiting.