Carve help

[13Z5M]

Hi,

I am trying to design a disk with three different carve depths. The wood thickness is .750". The outside ring would be .250" deep, the middle one .350", and the center .500.

I created a circle and made it a carve region a .250. Then I created a smaller circle, made it a carve region and made the depth .350. When I look at the design, it all looks the same depth.

What am I doing wrong?

Steve

[MikeMcCoy]

Did you make the inner ring additive?

[13Z5M]

No, Is that what I am doing wrong? I'll give it a try.

Steve

[13Z5M]

That did it. Thanks!

Steve

[bdehoyos]

something lije this :

try to play with the "marge" and "clip carving" properties

[MikeMcCoy]

I just did it and I had it backwards. Make the outside ring additive and it will work.

[13Z5M]

You are right. I did it backwards - which is why it worked. Thanks.

Steve