New to CNC carving

[C388548]

I just started my learning journey on the CW. I still have a long way to go! I have a question about the Universal Sled that I just built from a depot pattern. Where would I post that question on the forum?

Thanks so much
Bonnie

[oscarl48]

Try this thread. Good luck.

https://forum.carvewright.com/showth...l-Carrier-Base

[Dale]

I use the Universal Sled all of the time, if you have a question just ask or PM me.

[leviscowill23]

I use the Universal Sled all of the time, if you have a question just ask or PM mapquest directions.

Thanks! I appreciate the offer and will definitely reach out if I have any questions about the Universal Sled.

[tomhanks]

You can look for a section dedicated to project discussions or specific topics related to your project. Typically, forums have categories like "General Questions," "Project Help," or "Technical Support."
io games

[heatenough]

Really the forums are now open for simple communication and conversation. Do and ask questions with informational approaches in the 'General' or 'Help" topics.
geometry dash