Don't know if you plan on carving that way or just testing, but that would be an awful lot of unnecessary carving. Use your connected line tool to trace around the the part, just a little bigger. Copy offset would be the tool to use for this if you have the 2d Vector Drawing Suite. Minimize the carving time as much as possible. Again, I don't believe the piercing was even available until 2.something.
CarveWright CX Packaged System - starting at $2000
CarversClub 1 Year Subscription - $150.00/year
Adv. Support w/out CC membership - $25.00/issue
CarveWright Community Forum - PRICELESS!