I need to make a round Flat sign (NOT A CYLINDER) with a border around it, and I can not figure out how to get the border to show up,also the sign will be made from an imported photo if that makes a difference.
I need to make a round Flat sign (NOT A CYLINDER) with a border around it, and I can not figure out how to get the border to show up,also the sign will be made from an imported photo if that makes a difference.
What kind of border?
CarveWright CX Packaged System - starting at $2000
CarversClub 1 Year Subscription - $150.00/year
Adv. Support w/out CC membership - $25.00/issue
CarveWright Community Forum - PRICELESS!
Things to remember when doing a project like this (assuming this is what you are looking for):
1. place photo
2. place circle
3. give circle a carve region (depth same as photo)
4. select photo, right click and do Clip Carving - Inclusive
5. place another circle equal size on top of first circle
6. assign Select Bit > pick bit and assign depth
CarveWright CX Packaged System - starting at $2000
CarversClub 1 Year Subscription - $150.00/year
Adv. Support w/out CC membership - $25.00/issue
CarveWright Community Forum - PRICELESS!
A .25 border at a height of the original board, so the photo is on the carve region which is .125 lower than the board thickness
Thanks lynnfrwd that does work. I really appreciate the help