I have basic software, with center-line. Can't figure out how to use 60 v bit to carve text.
I have basic software, with center-line. Can't figure out how to use 60 v bit to carve text.
Highlight the words you want to use a *V* bit for then go to the *tool bar* and choose *Bit Select*, choose whatever bit you would like to use.
Do I need to choose center line, outline, or raster. I programmed one raster and no feather and one in center line. Will carve this week end to find out. Thanks for info.
Click on Centerline in the text box area then *Conform* in the tool selection area.
Bigger Text will require a V90 Bit.
Favorite Saying.... "It's ALL About the Brass Roller"..... And "Use MASKING TAPE" for board skipping in the X or breaking bits.
Follow ME on Facebook http://www.facebook.com/pages/Accoun...50019051727074
www.PoconoDigitalWoodshop.com
www.AccountabilityTag.com