Small text discussion time, again....... anybody having any decent results with text in the 1" - 1-1/4" high 1/2"-3/4" wide range. Even using a thin font like modern (not bold) and only going .035 - .062 deep, it still comes out too wide, causing too many chips where they are cles together, or in certain letters like a small "e" or any letters with little lines. Also, Designer shows render to be a lot cleaner than finished result. Machine seems to hiccup or something on some patrs of a letter, causing a dimple or erratic carving - little jog outside of the lines kind of thing. Tried bit optimization off, high, etc. Even tried to cheat and used a 60 degree vbit when it asked for the 1/16 carving bit, still not great. Any tips? Pattern carving otherwise is pretty good. Carving plaques in the 8"w x 10"l size and I need smallish text to fit more than 1 or 2 words on the project. All else fails, if someone could post some centerline fonts in different styles, along with small (not Caps) versions. There is some Edwardian posted, that doesn't really carve well in small sizes. Oh well............time to make more sawdust.