rotary jig

[Elmo Sr]

good morning,

I am looking for a chess pieces set I can turn on my rotary jig if one is available

thanks
ElmoSr

[fwharris]

Look at this... http://www.carvewright.com/game-of-t...able-part-1-2/

[ronboley]

I've looked for the same, but only have knight so far. Don't rmember where I got this. Probably on the forum. There are 3D chess set patterns on the various internet 3D sites if you have a .stl translator. I seem to be unabkle to open most of them though. Good Luck!

[Elmo Sr]

thanks I saw the knight, plus some others in the tips and tricks but the others were flat not turned and I did not do the knight. I might have to git the stl impoter

[Elmo Sr]

Look at this... http://www.carvewright.com/game-of-t...able-part-1-2/

Floyd thank you muchly for that,
ElmoSr
(Lonnie)

[ronboley]

Here's the chess set from Thingiverse....I only resized and reoriented them so you need to do some editing like on the Carvewright tutorial video for the rotary jig. Good Luck...and let us see your results!

[Elmo Sr]

thank you so much, I haven't been here much, recovering from surgery and moving. thank you very much for sharing

[Elmo Sr]

Here's the chess set from Thingiverse....I only resized and reoriented them so you need to do some editing like on the Carvewright tutorial video for the rotary jig. Good Luck...and let us see your results!

thanks again for these just struggling on resizing them