I am setting up a long board for a sign. It is 59.75" long by 7.75' wide. I have added 7 inches and my design keeps all the words on the board. When I do the startup in my machine, everything seems to work great, but when it starts to carve the words it is off the board by about an inch on the side opposite the control panel. I have retried several times but it does the exact same thing.
I have contact paper on the entire board and masking tape on the outside edge in the middle to make sure it gets a true reading of the width. The slide plate is in place and I can't think of anything else to try. I can upload the design if it would be helpful.
Any suggestions?