There are numerous threads I've been through on this issue but none have offered me a solution that has worked yet.
The screen say's the cut motor is running but it will not run for a project or test.
I've taken the cut motor out and plugged into the wires with an old extension cord and the motor turns right on so I know the cut motor is fine.
I've also by passed the switches on the cover to rule out a bad switch.
I just put in a brand new X termination board that I got today and that has done nothing.
Put in brand new roller switches with the wire that connects to the cut motor. (Not sure that would have anything to do with the cut motor but I kept getting check roller & stuck roller messages throughout the last few projects and thought maybe it had a switch to kill the motor when the roller error would come up)
Talked to LHR and the next step they said would be to send the controller in for testing but was wondering if anyone can think anything other to check before doing that. I'm really hoping its not the super expensive controller. Any thoughts on this one would be appreciated.
-Rob