when i scan the probe does not raise up just drags into the wood is this soft ware related ????
when i scan the probe does not raise up just drags into the wood is this soft ware related ????
jeff
DO NOT FEED ! THE DRAGON
I would try reformatting the card. Did you manually set the scanning depth or did you let it use the floor of your scanning sled?
RingNeckBlues
My patterns on the Depot
DC-INSERT It Just Sucks!
Proven to out perform all others!
Buy CarveWright
Colorado FaceBook Users Group
All patterns and projects that I share on the CarveWright forum are for your personal carving purpose. They are not to be shared, sold or posted on any other web site without permission from RingNeckBlues Designs.
fixed it LOL
jeff
DO NOT FEED ! THE DRAGON
What did you do?
RingNeckBlues
My patterns on the Depot
DC-INSERT It Just Sucks!
Proven to out perform all others!
Buy CarveWright
Colorado FaceBook Users Group
All patterns and projects that I share on the CarveWright forum are for your personal carving purpose. They are not to be shared, sold or posted on any other web site without permission from RingNeckBlues Designs.
I am having the same problem when I scan. How did you correct your problem. I have reformatted the card and I am able to lay everything out on the sled and set my depth but the probe just hits the side without going up.
Need help
Check the plug and wires. Also go to sensor check to make sure the switches in the probe are working. (0 - 7 - up arrow) The state should change from closed to open as you deflect the probe.