Anyone have Air Force aircraft mpc's? Thank You
Anyone have Air Force aircraft mpc's? Thank You
Hopefully I spelled Aardvark right.
F-16 Falcon mpc and pattern derived from 3d model built by salatiel. All credit and considerable skill go to him.
3d Model by Salatiel at http://www.blendswap.com/blends/view/58825. Released under Creative Commons Attribution 3.0 This means that you can use it for any purpose you see fit, even commercially, as long as you respect these requirements: You MUST give credit to salatiel.
This means that you can use it for any purpose you see fit, even commercially, as long as you respect these requirements: You MUST give credit to salatiel.[/QUOTE]
That seems only fair and the right thing to do.
Mike
All Gave Some,
Some Gave All.
My computer configuration and software used:
Gigabyte GA-990XA-UD3 Motherboard, AMD FX 6-core Processor Black Edition, 32 Gig DDR 3 Ram, Gigabyte HD 6450 Video Card with 1 Gig DDR 3 ram, Windows 10
Designer 2.007, Designer 3.102, Pattern Editor, Centerline, Conforming Vectors, 2d Tools, 3d Tools, DXF Importer, STL Importer and Rotary Jig.
Here is another angle for a model I built a while ago. I have this model as a pattern at different angles under insignias and military section. I also have a Huey, which the Air Force is still using in the northern tier bases. It the wrong model but its close. (Don't tell my friends. They would disown me.) A funny thing about helicopter pilots is, THEY HAVE TO TALK REALLY LOUD BECAUSE THEY HAVE ALL LOST THEIR HEARING.
I screwed up the mesh on the 3d model but before I go back and redo the model again from scratch here is what I got from this one. Can probably be cleaned up a little bit with pattern editor with blur and smooth. Still not completely unhappy but only an okay model. Right at the front of the cockpit you can see where my mesh was torn.
I could always say it was metal fatigue (I know...sad).
Pattern sculptor. Just sayin'.
CarveWright CX Packaged System - starting at $2000
CarversClub 1 Year Subscription - $150.00/year
Adv. Support w/out CC membership - $25.00/issue
CarveWright Community Forum - PRICELESS!
lol. You still have to have a decent 3d model to use pattern sculptor. Still learning designer 2.0. It is amazing software when paired with 3d modeling (edit) and the stl importer.
Great looking patterns. You're doing good work!
Tracy
World's largest supplier of custom carved firewood.