I don't know what is going on. I am attempting to edge rout a board. Have done a few so far without issues. But now when I attempt to do it, it passes through the machine the first time (takes very little off), then when it is feeding the board back through for the second pass it gets to a point where is starts moving the board forward and then back about 1/2", and it keeps doing this, and keeps going faster and faster, just back and forth, back and forth, until the belt stops moving.
If I hit stop then hit the resume it feeds the board through about three inches, then starts doing it again, but now if you hit the stop button it doesn't stop doing it. I have to turn the power button off.
Any ideas what is going on?
I have already tried a different board and get the same results.