I just got my machine back from LHR where it got the entire carve tight upgrade. This was my first carve in 4-5 years. I did a heart box, something I've done in the past. Starting with the lid, the machine carved the bottom of the lid first, I did the board flip, it asks for the cutting bit, I do it, it asks for the carving bit, I do that. It then carves the top of the lid just fine. It then asks for the cutting bit again, So I put it in, it goes through it's checks and says it's routing but never turns on the cutting motor. It traces the outline like it should and then when it gets back to the top center of the heart it breaks the 1/8" bit right off. I'm kicking myself for not stopping it, but why would the cut motor not turn on? Why doesn't it know the motor is not running? What should I check, something in the pattern I used?
Thanks,
Kipp