the bolt head and thread broke off on the adjustment for the feed tray
any suggestions on how to proceed
the feed tray is not level now
cant run job
cant remove bolt
the bolt head and thread broke off on the adjustment for the feed tray
any suggestions on how to proceed
the feed tray is not level now
cant run job
cant remove bolt
Last edited by kjposter; 05-07-2014 at 04:56 PM. Reason: add
I never did rely on those bolts, they seemed to fragile.
I have a 1 X 3 (or 1 X 4) turned on edge to support the roller.
If I had it to do over, I'd have supports as part of the cabinet.
Ken,
V-1, 2, & 3
When the People fear their Government, there is Tyranny.
When the Government fears the People, there is Liberty.
- Thomas Jefferson
You must be the change you wish to see in the world.
- Mohandas Gandhi
like that
thanks
That is an excellent set up...Im going to steal your idea!! Thanks for sharing...
Your adjusting blocks are a great idea! I sure will put it to use. Much easier to work with. Thanks for your idea.