This pattern had a goal post in it that did not carve. I am guessing that either I didn't set it up right or I don't know how to allow for the bit. The machine ask me for a 60 degree bit, I put it in and it did nothing except go through the motions of getting ready to carve, then ask me for the carving bit. The bit i was trying to use was a vermont american 1/4 inch bit and I had a split collet to put it in. Could it be that the bit was too short to be found by the machine or did I do something wrong in the software? I do have centerline text and conforming vector but I didn't choose c/l text.