Correct , changed the FCS cable twice , I can go to sensor check and readings are fine when I move the truck . But the very moment I press buton to start a project I get the error
Correct , changed the FCS cable twice , I can go to sensor check and readings are fine when I move the truck . But the very moment I press buton to start a project I get the error
Start U Member
Swap Controllers.... with caution....since Calibration Data is different... just get it to get past the point of the other machine...
AL
Favorite Saying.... "It's ALL About the Brass Roller"..... And "Use MASKING TAPE" for board skipping in the X or breaking bits.
Follow ME on Facebook http://www.facebook.com/pages/Accoun...50019051727074
www.PoconoDigitalWoodshop.com
www.AccountabilityTag.com
it is the controller board,, took the one out of problem machine and put in running machine and get the , E06-0313 error z axis stall as soon as i hit enter on project, New controller is over $300.
I do have a controller off a spare parts machine, can it be used? Can it be recalibrated for my machine?
steve
Start U Member
You should be able to swap that out and yes you will need to go through the calibration procedures. Any machine info (ID etc.) will be for the machine you took it out of.
RingNeckBlues
My patterns on the Depot
DC-INSERT It Just Sucks!
Proven to out perform all others!
Buy CarveWright
Colorado FaceBook Users Group
All patterns and projects that I share on the CarveWright forum are for your personal carving purpose. They are not to be shared, sold or posted on any other web site without permission from RingNeckBlues Designs.
is there a pdf on the calibration procedure?
"i found the pdf "
Start U Member
RingNeckBlues
My patterns on the Depot
DC-INSERT It Just Sucks!
Proven to out perform all others!
Buy CarveWright
Colorado FaceBook Users Group
All patterns and projects that I share on the CarveWright forum are for your personal carving purpose. They are not to be shared, sold or posted on any other web site without permission from RingNeckBlues Designs.
If your not going to turn it in for the purchase of another, I would love to buy it off of you to play with...
AL
Favorite Saying.... "It's ALL About the Brass Roller"..... And "Use MASKING TAPE" for board skipping in the X or breaking bits.
Follow ME on Facebook http://www.facebook.com/pages/Accoun...50019051727074
www.PoconoDigitalWoodshop.com
www.AccountabilityTag.com
I havent been able to reset calibration yet with different controller as of yet Al,( no time today) if i can get it going i will get with you on the bad controller
steve
Start U Member
Controllers have to be programmed by us and includes the machine serial number.
The controller has a $100 value when sent in to us, and you qualify as the purchaser.
CarveWright CX Packaged System - starting at $2000
CarversClub 1 Year Subscription - $150.00/year
Adv. Support w/out CC membership - $25.00/issue
CarveWright Community Forum - PRICELESS!
so controller i had on spare part machine will not work on machine i am trying to fix?
steve
Start U Member