OK not sure where to post this so here looks fine.
I am about to start carving my next STL model in hard wood. So normally draft and normal mode are out. Wood is too hard and I will be putting undue stress on the machine.
When I bring up the same carve in version 1.187 its carve time is 33 hours in optimal. Too long. But now that I just bough version 2.02 the optimal carve time is 88 1/2 hours. What gives? Even best time is 38 hours. Is the carving in 2.02 that much better that I can select normal and still make it look like optimal in the old version? What is different? I can not take a model that will need 10 carves and one week to now carve it over a month!
Help need advice.
Carvewright A machine 2007
Carvewright C machine 2013 DC-Insert
Mavric iMac i7 16gig latest version
Designer 1.187, Designer 2.04, Centerline Text, Conforming Vectors, STL importer, DFX importer, Pattern Editor and probe