Is it possible to set the outline route to 3 - 1/4 inch cuts instead of one complete cut. To avoid this problem I had.
Is it possible to set the outline route to 3 - 1/4 inch cuts instead of one complete cut. To avoid this problem I had.
Rick, Go up to where your mpc is displayed, go to where it says view,at the top, click on, make sure all the steps are correct for for the carving list. Just click one step at a time and see how it corresponses with what you told it to do, proper placement, lines line up where you want it to cut. I might be all wet ,but give it a try.
Capt Barry
Yes, I sometimes use 1/8" cuts on harder woods.
Morton
Have you considered that the cutting bit could be dull?
In my experience, the board can slip on the sand paper if the cutting forces get too large. I always do multiple passes while staying under the rollers at all times.
I do not think that the brass roller is actually in control during cutting. Once the x encoder is synchronized with the brass roller, I think the x encoder is used as the position reference. Any slipping of the board relative to the belts seems not to be detected.