I have a request .... During a carve or edge rout, If sun thin happens with the machine, the only option is to abort... Like the other day I was doin an edge rout, The machine measured then started routing.. It did 2 passes on the end and then started doin the first pass down the side.. When it reach the end of the board, it came up with edge detect failed,, no option to continue... If I start over again it wouldn't measure the board correctly because the one end has already been routed.. The machine already measured the board Y would it need to detect the edge and Y can't we have an option to continue... The machine has all the info it needs already...
Mans Quest for knowledge,,, means he'll always find a way !!