Here is a banner type thing I scanned. Looks pretty good except for the dot. I tried to edit it in the patten editor, but cant seem to find it and clean it up. Any suggestions appreciated.
Here is a banner type thing I scanned. Looks pretty good except for the dot. I tried to edit it in the patten editor, but cant seem to find it and clean it up. Any suggestions appreciated.
Very nice! Thanks!!
Steve
Centerline
Pattern Editor
Conforming Vectors
DXF Importer
STL Importer
2D Advanced Tools
Designer 1.187, 2.007 and **NONE** on Mac OS 10.15.6 and Windows 10 via Parallels on Mac
To find the dot in PE enlarge the pattern where the dot is and then you can erase or remove it. If you like you can e-mail the mpw file and I will find it for you and e-mail it back. Just send a PM and I will give you my address.
Ike
Todd done check your e-mail dots removed!
Ike
Ok here is the banner without the dots, Thanks to Ike. I just started scanning, and am glad to repay with some of these scans. I know i have used tons of patterns from the site. I hope some of you are able to use and enjoy these. Thanks again to Ike for finding the dots for me.
Thanks Will, For the Great Looking Scan
Ken
Ver 1.182 on XL Pro plus Ver 1.164 and 1.175 on Windows 7 Ultimate
It Never Fails * Till * You Say It Never Fails
Will, that is a nice pattern/scan you posted.
Using Designer 1.187, STL importer, Center line, conforming vectors, scanning probe/PE, and the ROCK chuck.
Eddie
Using Designer Version 1.187
Donations are always welcomed, thanks – send a check to my PO Box 652
BJB
PO Box 652
Yellville,AR 72687-0652
PM me for my e-mail address.