I do not know why some would take longer to slow down then others, but I do know the reason for the spin-up. With the old quick change chuck, if you didn't get the bit seated properly, the spin-up would make the bit fall out rather than going into the wood at full speed and shooting it out.
I was also told that everyone should make sure their software is up-to-date and not using older versions.
Also, I sent a link to this thread to an engineer to look at.
From what I understand, all B & C machines had the metal clip on the encoder.
Last edited by lynnfrwd; 11-02-2011 at 05:20 PM.
CarveWright CX Packaged System - starting at $2000
CarversClub 1 Year Subscription - $150.00/year
Adv. Support w/out CC membership - $25.00/issue
CarveWright Community Forum - PRICELESS!