Z axis fault 248
I have only used the scanning probe a few time with no problems, now all I get is Z axis 248. Any assistance you can render to resolve this matter would be greatly appreciated, thanks in advance for your prompt response.
After entering the start and ending points, I press enter and the probe goes down to touch the sled and stops with z axis 248. I am using the RC with the probe, is there any special ajustments that I must make to get this work properly. I have read the threads on the probe problems and have checked the probe to make sure it was clean and did not have any broken parts inside. I checked it via the sensor check and it remains closed not matter what I do to the probe and it's connectors, is it suppose to do that? Thanks again for your assistance.
Courage is being scared to death and saddling up anyway.