My machine seems to be measuring incorrectly, it went all the way to start carving but it was missing the end of the board by about an inch.. This was with "Stay Under Rollers = Yes). I am sure there is a calibration that I need to do but can't seem to find the exact one to start with..
I have recently upgraded to the heavy belts and also installed new gears.. I have carved since these replacements were done, however I don't think the machine has ever worked exactly right. It seems to be a battle to get a carving to go, it either stops with check roller, or project won't fit on board (which I assume is because of the bad measurements) etc.. One time I loaded a board into the machine and it kept coming up telling me to load a board. This is cabinet grade Oak, and I have never had a problem with loading it in the past.. I keep my machine clean (after each job), everything is lubed as it should be but it seems so picky lately..
Any help is appreciated.. Thanks..