Why is it when you type in the lenght, the width changes to anohter # is there another way to set that so its the same setting front and back when you do a 2 sided carve
Henry
Why is it when you type in the lenght, the width changes to anohter # is there another way to set that so its the same setting front and back when you do a 2 sided carve
Henry
Henry
Every one has a photographic memory. Some just don't have film.
I presume that you are talking about the sizing of patterns, rectangles , or squares within Designer.
These items are proportional, therefore, by changing a size entry, or dragging the RED dots you retain the ratio of the original figure. If you wish to change just one facet, try using the YELLOW dots in the middle of each edge.
Connected line figures could pose similar situations, if you have some items (lines or angles) "locked".
AskBud
As to a 2 sided carve, I think we need to see a sample MPC along with some info as to what you need to emulate.
Last edited by AskBud; 03-31-2011 at 11:32 AM. Reason: connected lines
AskBud Downloads =>> CLICK HERE
Lesson added 7/15/2012 Titles begin with "2D-3D Build a Pattern-Part-3"
CW Vacuum Head Project =>> CLICK HERE
AskBud Home Page =>> CLICK HERE <<=PC lessons or CW lessons
More than 1250 AskBud patterns vvv-CLICK BELOW-vvv
http://store.carvewright.com/manufac...ufacturerid=29