I just started a test carve, and it does not even give the Scale option and it measures the board, when you have "Conform" applied to centerline.
AskBud
I just started a test carve, and it does not even give the Scale option and it measures the board, when you have "Conform" applied to centerline.
AskBud
AskBud Downloads =>> CLICK HERE
Lesson added 7/15/2012 Titles begin with "2D-3D Build a Pattern-Part-3"
CW Vacuum Head Project =>> CLICK HERE
AskBud Home Page =>> CLICK HERE <<=PC lessons or CW lessons
More than 1250 AskBud patterns vvv-CLICK BELOW-vvv
http://store.carvewright.com/manufac...ufacturerid=29
Bud,
Thanks for the update. Sounds like your board size was good also..
RingNeckBlues
My patterns on the Depot
DC-INSERT It Just Sucks!
Proven to out perform all others!
Buy CarveWright
Colorado FaceBook Users Group
All patterns and projects that I share on the CarveWright forum are for your personal carving purpose. They are not to be shared, sold or posted on any other web site without permission from RingNeckBlues Designs.
"This will only effect you if you choose to scale your project at the machine i.e place a board of the wrong size in the unit and press to scale."
My thanks as well LG,
The 1st comment caused me a few moments of Buyers Remorse until you explained what was really involved on the CW but not in Designer.
Fair winds,
Capt Bruce
Kinney deSigns http://kinneydesigns.us
CarveWright START U Team Member.
30 year USN SEABEE, the original Weapons of Mass Construction.
Designer Ver 1.187 and 2.007, Ver.3.001 One 2009 B CW w ROCK and a 5th Year Anniversary C CW
Rotary Jig, 2D and 3D, Tracing Probe, DFX and STL Importers
.
If your board is a different size, you may resize your Design board, and then resize the entire design, and re-load to the Memory card. Highlight everything and make it a GROUP. Now highlight everything again, and drag the YELLOW point as desired. Caution: Do not use the "Center Icons", as they you center all items as directed.
AskBud
AskBud Downloads =>> CLICK HERE
Lesson added 7/15/2012 Titles begin with "2D-3D Build a Pattern-Part-3"
CW Vacuum Head Project =>> CLICK HERE
AskBud Home Page =>> CLICK HERE <<=PC lessons or CW lessons
More than 1250 AskBud patterns vvv-CLICK BELOW-vvv
http://store.carvewright.com/manufac...ufacturerid=29
Scaling is disabled on conforms, yes. This is because although you can scale the project at the machine, you cannot scale the size of the vector bit! As a result, we cannot accurately determine how the bit will affect the board being carved.
Some of you may also notice a new scaling prompt at the machine: "IGNORE SCALING". When you're not conforming, if the board width is slightly smaller than the project width, this 3rd option may pop up. It effectively cuts off the "north" edge (next to the sliding plate) of the width of the project.