do you have to belong to the special group to read the Articles. The two new posts with the title starting with Article am unable to access.
do you have to belong to the special group to read the Articles. The two new posts with the title starting with Article am unable to access.
I get "Sorry, you do not have permission to access this post" too Alan.....
---------------------------------------------------------------
George
Life is short....drink the good wine first!
I'm getting that also. They seem to be in a forum named "vBCms Comments".
I sent Lynnfrwd a PM about it earlier so I'm sure he'll fix it.
Until then you can access the "Tip of the Week #2" article from the "Home" tab....
or just go here --> http://forum.carvewright.com/content...-of-the-Week-2
Last edited by gwhiz; 07-27-2010 at 04:27 PM.
---------------------------------------------------------------
George
Life is short....drink the good wine first!
I don't know??? Have any of you ever been able to access ARTICLE notification posted under WHAT'S NEW?
The last tip of the week I was able to read it. this one, nope, do not have permission.
Using Designer 1.187, STL importer, Center line, conforming vectors, scanning probe/PE, and the ROCK chuck.
Eddie
Try it now.
(I feel like the Verizon Guy!)
But you can all access it from HOME (or the CarveWright Corner)?