[
USING BITS & PROBE WITH CARVETIGHT:

•New Scanning Probes will feature hard pressed steel collars
•Existing Scanning Probes can be updated with a slotted steel collet

Good luck,
Craig[/quote]
I'm updating my Old Probe to the CarveTight system using the Scanning Probe Adapter... There was a video online that showed how to make the swap-out, but I can't find it now. I don't remember if you have to use one of the 1/4" rubber spacers or not... Do you have any idea about where to find the video or if the spacer is required with the probe or not?