Originally Posted by
andes
Dan,
Rechecked the Y term cable -- its oriented and seated correctly
Andrea,
Where you able to locate the probe sensor in the options menu on the machine and if you did where you able to check to probe state?
Checking The Machine’s Onboard Sensors
The status of each of the machine’s onboard sensors can be accessed
from the LCD screen and keypad for the purpose of troubleshooting. To
access the Sensor Check menu simply select the “0” (Options) key at the
CarveWright Main Menu
or use the up/down arrows to locate the
Configurations Menu
and then press ENTER. Next, select the “7”
(Measure) key or use the up/down arrows to locate the Sensor Check
menu and then press
ENTER. Navigate through the different sensors and
associated status values using the up/down arrows.
Probe State
State – Open/Closed
With no probe installed, the Probe State will be displayed as Open. The
operation of the probe can be checked while installed in the quick changer
and plugged into the connector. Once installed the LCD will read Closed.
To check the operation of the probe simply reach in and deflect the probe
tip to the side. If the probe is operating correctly the displayed state will
change from Closed to Open.