new 1.161

[Lin]

Has the issue when using centerline been taken care of in the new download? I'm speaking of the way the spindle stops and starts over and over again during the cut? I have steered away from using CL thinking that when the next update was released it would be taken care of but I don't see it on the list.
Lin

[liquidguitars]

Lin,

That's normal i think no reasion to worry..

LG

[Lin]

I asked because it didn't use to do that in versions prior. Just seems like it will be hard on the spindle motor continously starting and stopping between each move and each letter. I sorta thought that it would be looked into after Al brought it up here on the forum.
Just my thoughts.
Lin

[flyingemt]

Downloaded and installed today, no issues to report. Currently running a 4 hour carve, seems to be doing fine.

[pkunk]

Caution on 1.611.... There's a problem with it running the bit too slow.
http://forum.carvewright.com/showthread.php?p=122873#post122873
Supposed to be fixed soon.