-
New Scanning Probe
Hello All,
I received my new Scanning Probe today, boy was I excited. I read all the paperwork that came with it. I registered the software, put the scanner probe in the machine, attached the the head connector to the machine on the left hand side and the probe cable to that. Used the keypad just like the directions said. Pushed "0" for the Configuration Menu, pushed 7 for the Sensor check and nothing happened. The directions say that when you deflect the probe the displayed state will change from Closed to Open. I could never get that to happen. Any help would be appreciated. Thanks.
Brad
I have read more on the forum and so far I have taken the probe apart to make sure everything was connected - it was, I blew out the connector - that did not help.
Last edited by BradJulian; 12-12-2008 at 07:33 PM.
Reason: Troubleshooting update
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules