Originally Posted by
Lincoln96
I haven't made any of my own designs yet. I'm just using patterns from the CW pattern depot at this point. The wood I use is dry, less than 10% moister. So far I've just been using the normal setting for quality, not best or optimal. I've also ran a wire from metal on the CW to metal on my dust system.
Something that does have me scratching my head is the depth of cut. I want to cut through on a piece of 1.5" material using a long 1/8" carving bit. The program says no can do. I even reduced the thickness to 1.25 and get the same message. I thought the long 1/8" bit was good for up to 2"?
Carving bits are for carving not cut paths.
CarveWright CX Packaged System - starting at $2000
CarversClub 1 Year Subscription - $150.00/year
Adv. Support w/out CC membership - $25.00/issue
CarveWright Community Forum - PRICELESS!