Results 1 to 10 of 10

Thread: Carve Malfunction

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 02-14-2019 #1
    Oldtrainerguy's Avatar
    Oldtrainerguy
    Oldtrainerguy is offline Junior Member
    Join Date
    Sep 2010
    Location
    Houston Area
    Posts
    102

    Default Carve Malfunction

    I have had problems with my machine on the first pass of a carve. I am attaching a photo and need help with the solution.
    I am running the latest version of the software. Basically on the first pass it goes too far and wont center on the board. It asks to center on board an I tell it yes, then it puts it at the top. Temp 72 degrees Suggestions welcome.


    Thanks
    Attached Thumbnails Attached Thumbnails IMG_0770 (1).jpg  
    Old Trainers never die, The tape just doesn't sitck anymore!
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules