I was just running a new project and got a Z-Axis stall about 15% into a 6 hr carve. My machine has 200 hrs on it right now. I turned it off and gave everything a good thorough cleaning and no matter what project I try to open it gives me a stall message right away. I have gone into user options to test everything and X and Y are fine. But on both the Z-Axis and Cut Motor test I get the stall error. The z truck does move a fraction, id say about 1/32 and then the error but it does move freely by hand. If anyone can please give me some help or ideas I would greatly appreciate it. Thanks