-
double carve ?
How about this........Ive been carving a tree of life for awhile now. A while back was the first time I saw it but what it did was almost like it carved it twice but shifted about 1/4" to the left on one of the carves. does that make since ? I use the same pattern each time I do this carve. after that carve I have used it again several times with out it happening. Then yesterday it did it again. I now know to watch for it. It shows up in the design software, but not every time. now Ill really get you to thinking. It only shows up when you rotate clockwise 90. any ideas ???????? I know its not 2 layers of the design.
ok next issue.........
When carving just about every design. the bit does great and smooth on the one side ( keyboard i think ) of the design....on the other side it leaves a it rough or furry. I usually carve on best with bit optimization varying. this happens on pine, oak and ash. oh and with a brand new 1/16 bit
any help is appreciated. thanks y'all
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules