I know this is kinda...... dumb, but math was not my favorite subject. So how or what is the formula to figure out that .750 is 3/4 or .625 is 5/8? I know the CW does this automatically, but I'd like to know the formula on how this is done. Thnx
I know this is kinda...... dumb, but math was not my favorite subject. So how or what is the formula to figure out that .750 is 3/4 or .625 is 5/8? I know the CW does this automatically, but I'd like to know the formula on how this is done. Thnx
JerryB:.
CarveWright START U Team Member
Using 1.187, Conform, PE/Probe, Centerline.
"Let's start sharing PTNs instead of MPCs so ALL SW versions can view & share"